Screw the securing bolt through the adapter plate and again tighten by hand, giving it a further quarter turn with a socket. Lightly lube the face of the adapter plate and place it onto the spin-on adapter. Lightly rub a small amount of oil around the rubber seal of the new adapter and screw it on as tight as you can by hand, using a socket give it a quarter turn more.įrom now on during this guide we will show you the steps off the car as it makes it alot easier to understand. Remove the oil filter housing with a 27mm socket, you will need something to catch the excess oil. To get started you will need to drain the oil from the car as you would if you were doing an oil change. The kit shown was put together by ourselves so it may vary slightly from kits you can buy elsewhere, the basic principle however remains the same. Oil coolers are vital in prolonging the life and performance of your car, especially if your using it on the track.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |